home > end users > maintenance
 
 

coiling-doors-motorized-safety-DIV 08

Care and Maintenance:

Our products require very little user maintenance. As with any protective device, we recommend regular inspection and testing. Following these basic tips will help extend the life of your Miller Edge products.

Sensing Edges:

Cleaning
• Clean with a soft damp cloth. A solution of mild household detergent
or dishwashing liquid may be used.

Maintenance
• Do not paint
• Inspect regularly for cuts, scrapes or punctures as these could lead
to damage of internal switching mechanism.

If the Sensing Edge is damaged, call your local gate professional immediately for service.

Sample Testing Procedure download Sample test procedure

 


 

Guardian Mats:

Cleaning

• Common dirt or dust: Sweep clean with soft bristle broom.
• Spots or Stains: Spot clean by wiping with a clean, damp (not wet) cloth. A non-abrasive, mild household
   detergent solution may be used if needed.
• Oil, Grease Spills: Minimize exposure to oils. Cat litter has excellent absorbent properties and may be used to remove
   oil from the mat surface. Generously sprinkle litter over the oil, then sweep clean with a soft bristle broom.

Maintenance

• Perform visual inspections for any cuts, scrapes or punctures that may damage the internal switching device
• Inspect for any cut, frayed or damaged wires
• Perform testing on a regular basis

 

Photo Optic Products:

Cleaning
• Wipe with a clean lint free cloth or with soft bristle brush.

Maintenance
• Make sure all wiring connections are secure
• Inspect for any cut, frayed or damaged wiring

Sample Testing Procedure: Patriot download Patriot Sample test procedure

 

Edge Transmitters:

Cleaning
• Wipe with a clean lint free cloth or with soft bristle brush

Maintenance
• Replace battery at least once per year. It’s a good reminder to schedule this at the same time you
   replace smoke detector batteries in your home or office.
• We do not recommend replacing the battery yourself, but if you must, be aware that the lid gasket must
   be intact and in the proper position to maintain the watertight seal. Water damage caused by an incorrect
   assembly is not covered by your warranty.
• We recommend calling a professional door or gate company to replace the transmitter battery and perform
   an overall system safety check.

 



     © MillerEdge Inc., All Rights Reserved :: Sensing Edges | Safety Mats | Photo Optics | Accessories | Custom | Contact Us :: An Effusion Design